chiliGREEN B5130 - Manual (Page 41)

3.75G/HSPA Module USIM Card Installation 1 - 17
Quick Start Guide
1
3.75G/HSPA Module USIM Card Installation
If you have included an optional 3.75G/HSPA module in your purchase option (Factory Option for Model A
Computers Only), follow the instructions below to install the USIM card (which will be provided by your ser-
vice provider), and then run the Mobile Partner application. See
“Mobile Partner” on page 7 - 31 for instruc-
tions on installing the program etc.
1. Turn off the computer, and turn it over and then remove the battery (slide the latches in the direction indicated
below and slide the battery out).
2. Insert the USIM card (at the rear of the battery compartment) as illustrated below until it clicks fully into position,
and replace the battery.
Figure 1 - 9 - Battery Removal & USIM Card Insertion

USIM Card
Orientation
Note that the USIM
card’s readable side
(with the gold-colored
contacts) should face
upwards as illustrated.