chiliGREEN E7130 - Manual (Page 91)

BIOS Utilities
Advanced Menu 5 - 9
5
On Board JMicron Power Saving (Advanced Menu > Advanced Chipset Control)
You can adjust the power settings for the card reader from here.
Total Graphics Memory (Advanced Menu > Advanced Chipset Control)
Use this menu item to set the amount of system memory to be allocated for use by
Intel
®
Dynamic Video Memory Technology for the graphics device. The default
memory size allocated is MaxDVMT (up to 1748MB) and this may be adjusted to
128MB or 256MB (by pressing the spacebar to adjust) if required (see
“Dynamic
Video Memory Technology” on page B - 2 ).
Bluetooth Power Setting (Advanced Menu > Advanced Chipset Control)
You can adjust the Bluetooth module power setting to your preference. The default
setting (Disabled) will see the Bluetooth module powered off when the system is
started up or restarted. Enabling the power setting will have the module retain the
last power status (on or off) before any restart or shut down.
SATA Mode (Advanced Menu)
You can configure SATA (Serial ATA) control to operate in either IDE (native/
compatible) or AHCI (Advanced Host Controller Interface) modes from this menu.
The SATA mode should be set to AHCI mode for this system (unless you are sure
your hard disk can only operate in IDE mode). If you are unsure of the mode your
hard disk supports contact your service center.

SATA Mode
Selection
If you have installed the
Windows 7 operating
system with AHCI mode
enabled (default set-
ting), DO NOT disable
AHCI mode (if you wish
to disable AHCI mode
you will need to reinstall
the Windows 7 OS).