Carter-Hoffmann PHW1822 - Manual (Page 6)

START UP
1. Prior to use, thoroughly clean the interior of the unit, per
the instructions in this manual (see page 11). Familiarize
yourself with the controls.
2. The cabinet is equipped with two heating systems, one
for each side, that are then plugged into a single junction
box at the base of the cabinet. Make sure the individual
heaters are plugged into the junction box prior to plugging
in the cabinet.
3. The power cord for the cabinet is located at the rear of
the cabinet and exits at the top of a raceway in the center
of the back panel. Plug the power cord of the cabinet into
a grounded outlet with the appropriate electrical service
DO NOT MODIFY CORD PLUG.
4. Turn temperature dial to highest setting (210°F).
5. Do not load product into the cabinet. Allow the heat to
remove any residual oils which may adhere to inside
metal surfaces. A slight emission of smoke is common
during the first few hours of operation.
If necessary, contact a licensed
electrician to install an appropriate
208 volt, 60 Hz, 3063 watt, 15
Amp circuit. NEMA L6-20P plug.
DO NOT use an extension cord.
Installation procedures must be
performed by a qualified technician
with full knowledge of all applicable
electrical codes. Failure could
result in personal injury and prop-
erty damage.
Damage to unit due to being
connected to the wrong voltage or
phase is NOT covered by warranty.
T he ground prong of the power
cord is part of a system designed to
protect you from electric shock in
the event of internal damage.
DO NOT cut off the large round
ground prong or twist a blade to fit
an existing receptacle.
CAUTION:
Electrical Shock Hazard
Unit is not waterproof, to avoid
electrical shock, keep unit from be-
ing submerged in water. Do not
operate if unit has been in contact
with water.
IMPORTANT:
IMPORTANT:
Not under warranty
WARNING:
Risk of personal injury
WARNING:
Risk of personal injury
Raceway located at
back of cabinet.
Cord exits from the
top.
6