Online manual not for resale purposes – BLITZ Scion xB-xA Compressor System User Manual

Page 17

33. Use #19 throttle body gasket and
reinstall the throttle body and the throttle
cable bracket.

* Use factory bolts and nut.

35. Attach tensioner pulley as shown in
illustration. **Make sure that #14 pulley is
installed as shown, with indent facing towards
spacer.

34. The factory air cleaner hose is re-
installed.
Use factory hose clamps. Make sure all
vacuum lines are installed in the correct
position.

Throttle Body

Original throttle

Cable bracket

Genuine air cleaner
hose

14. Rib equipped pulley

⑭

Nut

20. Belt

36. Install compressor belt (#20).

* Be sure the ⑭

nut holding the tensioner pulley

is not tight.
* Be sure the tensioner pulley is all the way up.
* Please put the belt over the water pump last.
* Adjust tensioner until belt is tight, then tighten
down ⑭

nut.

⑭Collar nut

14. Pulley

15. Spacer

Indent side

12. Tensioner bolt

7. Tensioner
Bracket
Ａ

Online Manual Not For Resale Purposes