Online manual not for resale purposes – BLITZ Scion xB-xA Compressor System User Manual

Page 13

15. Attach compressor onto the intake
manifold. Make sure the #5 Compressor
gasket (1) is installed.

※

In place of stud bolt use

⑫

nut (5).

Use the

①

bolt (1) for the last open hole.

16. Use #9 Compressor bracket to attach
compressor and intake manifold.

Use the

③

bolt (1), the

⑦

bolt (1), and the

⑭

nut (1) as

shown in illustration.

*Hint: Using #11 Bracket, attach flat end to

⑦

bolt, prior to bolting on #9

Compressor Bracket. Leave a little play
on #11 Bracket, it will allow the
installation of the dip stick easier. (refer
ahead to Installation #25)

17. Install

⑰

Stud bolt (3) as shown in

illustration.

18. Remove transmission bolt as shown.

1. Compressor

3. Intake manifold

9. Compressor
bracket

⑦Flange bolt

③

Flange bolt

⑭Collar nut

1. Compressor

3. Intake manifold

⑰Stud bolt

Transmission
bolt

Online Manual Not For Resale Purposes