Beka SG floor stand - Manual (Page 2)

ASSEMBLY DIAGRAM
Hardware: All bolts should go through from the inside to provide smooth inside surfaces, to
avoid snagging yarn and clothing during use.
#1: 1
1 /
2
” bolts, smooth tops (4)
#2: 2” bolts, smooth tops (4)
#3: 3” bolts, slotted tops (2)
All bolts are secured with a flat washer (10), a lock washer (10) and then a wing nut (10).
Note: the lock washers always go between the flat washers and the wing nuts.
Aluminum Support Brackets (4): These are positioned in the slots provided in the 4 uprights,
and secured with a bolt (#1) in the proper hole to give a comfortable weaving height.
___________________________________________________________
NOTE: for an SG-20 loom, use
the inner 2 holes in the cross
bar. Use the 2 end holes for an
SG-24 loom (sketch shows SG-
24 setup).
cross bar
#2
#2
#2
#2
#1
#1
#1
#1
#3
#3
long upright
long upright
short upright
short upright
slot
slot
file:SG floor stand instructions 02/17/00
base piece
base piece