Beka Toy chest - Manual

Beka, Inc. • 542 Selby Avenue • St. Paul, Minnesota 55102 • USA
1-888-999-2352 • www.bekainc.com • 651-222-3965 fax
TOY CHEST
Parts:
Baltic Birch Hardware:
1 – 1/2” X 11-3/4” X 22-3/4” Back 4 – Casters
1 – 1/2” X 11-3/4” X 22-3/4” Bottom 1 – 3/4” X 21-1/4” Dowel
2 – 1/2” X 13-5/8” X 13-5/8” Cart Sides 8 – 10 X 1-1/4” Phillips, Flat Head Screws
1 – 1/2” X 6-1/4” X 23-1/4” Front Piece 8 – 10 X 1-1/4” Phillips, Truss Head Screws
Hard Maple
2 – 1-3/8” X 1-3/8” X 15” Back Supports
2 – 1- 3/8” X 1-3/8” X 13-5/8” Bottom Supports
Assembly Instructions:
Fig. 1
Step 2)
Using flat head screws, attach back (recessed
holes out) to one back support. Make sure the
large “dowel hole” faces inward, as shown. Fig. 2
Model # 06201
Step 1)
Using flat head screws, attach the bottom
(recessed holes up) to the bottom supports. Make
sure the large “caster holes” face down and the
predrilled hole closest to the end of each support
is near the edge. The bottom assembly should
look like figure 1.
Step 3)
Insert dowel into remaining back support and then
into the previously attached back support. Next,
secure unattached back support to back, again us-
ing flat head screws. The back assembly should
now look like figure 3. Fig. 3