Beka 3-sided cart - Manual (Page 2)

Step 5)
Using the remaining truss head screws attach the
back assembly to the same side piece. Attach re-
maining cart side, holding the bottom and back as-
semblies in place.
NOTE: Back assembly should rest on bottom
supports.
Fig. 5
Step 6)
Carefully push casters’ metal stem into holes lo-
cated on the underside of cart so they are fully
seated.
Fig. 6
Step 4)
Using truss head screws, attach one cart side to
the bottom assembly., as shown in fig. 4.
Fig. 4
Step 3)
Insert dowel into remaining back support and then
into the previously attached back support. Next,
secure unattached back support to back, again us-
ing flat head screws. The back assembly should
now look like figure 3. Fig. 3