Barranca Diamond HP30 Slab Saw - Manual (Page 21)

21
TROUBLESHOOTING
Saw Will Not Start
Check power cord and receptacle.
Motor Overheating
If motor overheats, allow to cool for 2 to 3 hours, push reset button
with power disconnected, hookup power cord and resume cutting
by pulling the power switch to the ON position. All motors have
automatic thermal protection and will shut off if overheated. Do not
use long (25'+) drop cords.
Vise carriage cannot be moved by hand when clutch is disen-
gaged
Adjust clutch, see clutch adjustment procedure on page 16. Check to see if carriage is disengaged from screw
feed by placing clutch lever in 12 o'clock position and moving carriage by hand over rails.
Vise carriage does not move automatically when clutch is engaged
Clutch block thread may be stripped or worn. Remove and replace bronze clutch block.
Blade will not cut properly
Check for damaged or glazed diamond cutting kerf (segments). Replace damaged blades or resharpen dull
segmented blades.
Motor reset button
HP30 MAINTENANCE & TROUBLESHOOTING