Barranca Diamond HP30 Slab Saw - Manual (Page 10)

10
HP30 SPECIFICATIONS
CARRIAGE FEED ENGAGE/DISENGAGEMENT
Lever operated clutch system using silicon bronze shoe with block (adjustable set screws).
INDEXING OR ROCK CUT WIDTH CONTROL
Crank handle operated stainless steel screw system.
TANK & HOOD COVER CONSTRUCTION
11 gauge steel box-construction, 11 gauge hood with acrylic plastic viewing window.
TANK LEGS
11 gauge steel construction with locking casters.
OIL SLUDGE DRAIN
2” drain cap. Drain placement is on front at the bottom of saw tank.
ON/OFF AUTOMATIC POWER CONTROL
Saw has adjustable chain for automatic shut-off control of power on/off switch.
DEPTH OF CUT
30” blade: 12 inches but will vary depending on size and shape of specimen.
MATERIAL TYPES
Barranca Diamond Highland Precision Slab Saws can cut a variety of material types including lapidary rock,
natural and artificial glass, and gemstone minerals.
NOTE: Highland Precision Slab Saws are not designed to cut wood, ice, synthetics, graphite carbon, plastics,
or ferrous metal materials.
UNPACKING & ASSEMBLY
Your Highland Precision Slab Saw has been shipped from the factory thoroughly inspected and tested. The
blade has been factory installed and arbor nut securely tightened. No assembly is required. Do not over-tighten
the arbor nut prior to use.
Remove the saw from the pallet by unbolting legs from crate pallet and place it on a flat surface using a forklift.
Install casters on legs – one at a time - prior to operation.
CONTENTS
In the wood crate, you will find one (1) Barranca Diamond Highland Precision Slab Saw, one (1) 303 segmented
diamond blade, one (1) owner’s manual, one (1) warranty card, and (4) leg casters.
TRANSPORT
Do not attempt to move a saw that is not mounted on casters without a forklift or floor jack.
Place the hood in the DOWN position and latch when transporting.
Be sure power cord is disconnected.
WARNING