Autoquip TRUCK LEVELER - SHALLOW PIT MOUNT - Manual (Page 23)

23
4. The bottom of the skirts rests on the ground; they are not attached to the concrete.
Confirm that the folds are correctly stacked and are square with the sides of the
Surface Mounted Truck Leveler.
5. Raise and lower the platform to confirm that the skirts are operating correctly. If he
site is subject to wind, a _” diameter steel round bar (provided) should be inserted
into the bottom pockets of the skirts and lagged to the ground with conduit clamps.
Final Preparation
1. It is recommended that two concrete-filled bollards be placed 6” in front of the
cylinder towers. The top of the bollards is to be 66” above the apron grade and 2”
from the edge of the platform.
2. Check the oil level in the power unit reservoir. See “Oil Requirements” in the
Maintenance section.
3. Remove all debris from the installation area. Touch up any scuffed and/or damaged
painted surfaces with touch-up paint.
WARNING!
All warning and information decals should be in place as outlined in the
“Label Identification” section. If decals are missing or damaged, they
should be replaced with new ones. Contact an Autoquip representative for
replacements
.
INSTALLATION INSTRUCTIONS