Autoquip VERTICAL RAM LIFTS - DUAL RAM - Manual (Page 36)

36
PROBLEM POSSIBLE CAUSE AND SOLUTION
Lift will not lower. • The down solenoid may be malfunctioning.
• The structural members may be in a bind.
• The piping is obstructed or broken.
• The return filter may be clogged.
• Should the above steps not correct the problem,
contact Autoquip to obtain instruction for further
action.
Lift raises slowly. • The structural members of the lift may be binding.
• The piping is obstructed or broken. Where pipe is
used, check for obstruction in the line.
• The hydraulic line or hose may be leaking.
• The oil viscosity is not suited for the environmental
conditions. Refer to “Routine Maintenance” section
for oil requirements.
• Check the oil level in the reservoir.
• The motor voltage/wiring may be incorrect.
• The suction screen may be clogged. Remove and
clean the screen. Drain and replace the oil.
• The suction line may be leaking air due to a loose
fitting. Tighten as needed.
• The breather holes in the reservoir fill cap may be
clogged. Remove and clean.
• The power unit pump may be defective.
Lift lowers slowly. • The structural members of the lift are binding.
• The tubing or hose is obstructed or broken. Where
pipe is used, check for obstruction in the line.
• The oil viscosity is not suited for the environmental
conditions. Refer to “Routine Maintenance” section
for oil requirements.
TROUBLESHOOTING ANALYSIS