Autoquip VERTICAL RAM LIFTS - DUAL RAM - Manual (Page 23)

23
OIL LINE TO RUN BEFORE
SECTION "A-A"
STEEL CASING, IF REQUIRED
3 6 " DIA. X 1 /4 " WALL
( BY PIT CONTRACTOR)
FOOTING
REINFORCING BAR
CLEAN SAND BACKFILL
(BY INSTALLER)
WELDED TO CASING
(BY PIT CONTRACTOR)
CONCRETE BUMPERS
( BY OTHERS)
TYP. ( 4) CORNERS
9 " ROUND OR SQUARE OPENING
CONCRETE IS POURED.
FOR SETTING NON-ROTATOR
(BY OTHERS).
UNION
3 6 " ROUND OR SQUARE OPENING IN
PIT FLOOR FOR SETTING RAM.
PLATFORM LENGTH
PIT LENGTH
(PLATFORM LENGTH + 2 " )
CENTER OF PLATFORM
PIT DEPTH
3 6 " APPROX.
TRAVEL
LIFT
BLACK STRIPED TAPE.
SIDES WITH YELLOW AND
BEVEL TOE GUARDS ON ( 4)
HANDRAILS AND
SNAP CHAINS NOT
SHOWN FOR CLARITY.
" A "
TYP.
1 8 "
RAM LOCATED IN
1 8 "
TYP.
LOCATE WHERE CONVENIENT.
REMOTE POWER UNIT:
TOP OF RAM FLANGE.
1 3"
RAM SETTING DIM.
FROM FLOOR LEVEL TO
RAM LENGTH
PIPE CHASE
(BY OTHERS)
UNION
CURB ANGLES
(BY OTHERS)
NON-ROTATOR ASS,Y.
ELBOW
1 " TYP.
1 " TYP.
WIDTH + 2 " )
(PLATFORM
WIDTH
PIT
1 2 "
WASHER PLATE
& RAM BOLTS
CONCRETE BUMPERS
( 4 ) CORNERS
( BY PIT CONTRACTOR)
WIDTH
PLATFORM
" A "
Figure 9 General Arrangement - APE
INSTALLATION INSTRUCTIONS