Autoquip SERIES 35 LOW PROFILE - Manual (Page 26)

INSTALLATION INSTRUCTIONS
PROCEDURE FOR A LIFT ORDERED WITH A TOE INDICATOR SKIRT
1. Position the platform in the raised position. Install the maintenance locks (see
“Lift Blocking Instructions” ). Position the Toe Indicator skirt with the weight rod
pocket at the bottom and the Internal Horizontal Velcro strip at the top. See
Figure 12.
2. The skirt should be mounted to the platform sides to allow the skirt to extend
approximately 8” below the bottom of the platform, see Figure 12. At the Skirt
starting point, the skirt should have a Vertical Exterior Velcro strip and an
Internal Horizontal Velcro strip. Use the Horizontal Velcro strip with adhesive
back to attach the skirt to the platform sides, typical for all (4) platform sides.
Start the skirt 1/2” from Corner #1 and wrap the Toe Indicator Skirt ‘Clockwise‘
around the side of the platform. Keep the skirt smooth and tight during the
clockwise installation.
3. Before overlapping the skirt at Corner #1, insert the Weight Rods into the
weight rod pockets. (1) Weight Rod into Side ‘A’ pocket and (1) Weight Rod
into Side ‘B’ pocket. Check the opposite ends of each weight rod to insure the
weight rod is fully inserted into each weight rod pocket. Wrap the skirt around
Corner #1 and attach the Vertical Interior Velcro strip on Side ‘A’ to the Vertical
Exterior strip on Side ‘B’.
4. After installing the Weight Rods in Side A & Side B, we need to install Weight
Rods into Side ‘C’ and ‘D’. At Corner #3, on the OUTSIDE surface cut a 1”
(max.) Vertical slot in the TOP of the weight rod pocket. Insert weight rods in
this slot, (1) for Side ‘C’ and (1) for Side ‘D’. The un-cut portion of the weight
rod pocket will retain the weight rods.
26