Autoquip COIL TRANSFER CARS - Manual (Page 15)

15
PROCEDURE FOR A LIFT ORDERED WITH AN ACCORDION SKIRT
1. Position the platform in the raised position. Install the maintenance locks (see “Lift
Blocking Instructions” section). Position the accordion with the weight rod pocket at
the bottom and the mounting collar at the top. The breathable material when
provided must be positioned at the top of the skirt with the mounting collar.
2. Slip the skirt over the end of the platform. Turn the skirt as required to slide over the
other end of the platform and leg assembly. The skirt should be in position under
the platform while enveloping the base assembly.
3. See Figure 10 and select the correct mounting configuration (Figure 1, 2, or 3).
Figure #1: Mounting an Accordion Skirt Onto the Platform Side
Raise one side of the skirt along with a skirt -mounting bar (1/8” x 1”) to (1) side of
the platform. When possible, center the skirt-mounting collar and skirt-mounting bar
(1/8” x 1”) on the platform side. Align the pre-drilled holes in the side of the platform
with the skirt-mounting bar holes and punch holes in the skirt-mounting collar. Push
a nylon drive rivet through each hole in the skirt-mounting bar. Hammer the
aluminum pin into the rivet until flush with the rivet head. Repeat mounting process
for the remaining sides of the accordion skirt.
Figure #2: Mounting an Accordion Skirt Underneath the Platform
Raise one side of the skirt along with a skirt-mounting bar (1/8" x 1") to the
underside of the platform skirt support bar. When possible, center the skirt mounting
collar and the skirt-mounting bar (1/8” x 1”) on the platform support bar. Align the
pre-drilled holes in the skirt support bar (picture frame) with the skirt -mounting bar
holes and punch holes in the skirt-mounting collar. Push a nylon drive rivet through
each hole in the skirt-mounting bar. Hammer the aluminum pin into the rivet until
flush with the rivet head. Repeat mounting process for the remaining sides of the
accordion skirt.
Figure #3: Mounting an Accordion Skirt Onto the Bevel Toe Guard
Raise one side of the skirt along with a skirt-mounting bar (1/8” x 1”) to the side of
the bevel toe guard. When possible, center the skirt mounting collar and the skirt-
mounting bar (1/8” x1”) on the platform bevel toe guard. Align the pre-drilled holes in
the bevel toe guard with the skirt-mounting bar holes and punch holes in the skirt-
mounting collar. Push a nylon drive rivet through each hole in the skirt-mounting
bar. Hammer the aluminum pin into the rivet until flush with the rivet head. Repeat
mounting process for the remaining sides of the accordion skirt.
4. Install weight rods into the weight rod pockets at the bottom of the accordion skirt.
Install the spring tempered wire rods into the pocket of black convolutions.
INSTALLATION INSTRUCTIONS