Anchor CENTURY 100 WIDE, ONE-PIECE - Manual (Page 2)

2
MANPOWER REQUIRED
Six experienced installers should be able to
assemble a 100’ x 100’ tent in approximately
six hours.
TOOLS REQUIRED
Sledge Hammers
Stake Driver
2 Measuring Tapes
Front End Loader
INSPECT SITE
Caution:
Consult your local utility locator service or the
National Utility Locating Contractors Association
(NULCA) prior to installation.
Prior to actual tent
assembly, be sure to look up, down, above &
below for obstacles, pipes, wires, trouble, etc.
LAYOUT & CHECK
Utilize parts list for a quick I.D. and a check list to
ensure that you have all the parts.
IMPORTANT:
The installation of this Century Tent should be performed/supervised by knowledgeable tent installers with a clear
understanding of safety issues as well as the methods of anchoring. The requirements as specified with blue print
(supplied by Anchor Industries Inc.) must be followed. The installer/owner must read the assembly instructions com-
pletely prior to any installation. Particular attention must be given to anchoring! See Caution Statement on back page
of this manual.
Parts Illustrations
Pole Cap Fabric
Top Weldment
1/2” x 7 1/2” Hex
Head Cap Screw
with nut.
2 Pc. Center Pole
( 4) 3/4”
Shackles
(4) 1” x 30” Double
Head Stakes
1” x 10” Hex Head
Cap Screw with lock
washer and nut.
Pole Cap Frame
Base
Plate
Optional 8” Center Pole
Assembly for “Ring Style”
Construction
Pole Cap
Top Weldment
1/2” x 8” Hex Head
Cap Screw with
washer and nut.
Top Pole Extrusion
Bottom Pole
Extrusion
Splice
Tube
1/2” x 8” Hex Head Cap
Screws with washers
and nuts for attachment
of splice.
(4) 1” x 30” Double
Head Stakes
1” x 10” Hex Head
Cap Screw with
washer and nut.
Base
Plate
Standard 7” Fluted Center
Pole Assembly for “Ring
Style” Construction