Anchor MODULES 30’, 40’ AND 60’ WIDE SYSTEMS - Manual (Page 4)

5
RAISE CENTER POLES
Raise the center poles nearest to the
wind direction to approximate the posi-
tion. Position one installer to guide the
center pole pin through the hole to pre-
vent snagging or tearing of the fabric as
the pole is being raised to position.
Tie off the jump rope.
At this point it is required to properly
anchor bases of all center poles to pre-
vent movement.
JUMP ROPE
6
Tension web guys with ratchets.
Protective covers are recommended for
all stakes.
7
TENSION SIDE POLES
TAKE DOWN
USE EXTREME CAUTION WHEN
REMOVING ALL POLES
1. Spread the ground cover.
2. Slant the side poles inward.
3. Remove the center and side poles.
4. Reverse the installation steps.
IMPORTANT
Check the web guys periodically for tight-
ness and good condition.
Store the tent in a cool, dry area. Never
store the fabric wet or damp.
JUMP ROPE
2’-8”
4
RATCHET
WEB GUY WITH SINGLE YOKE
SHOWN WITH 2’-0” STAKE BAR.