Altman Lighting Track Lighting: GLOBALtrac tec 2-circuit / 2-neutral track system - Manual (Page 8)

Pendant Suspension
A. Pendant wiring B. Mechanical pendant support detail
detail
Outlet box
Thread:
3/8 inch - 18 IP Thread:
3/8 inch - 18 IP
Metal
bracket
Metal
bracket
2 Lock nuts
2 Lock nuts
SPXX Stem
and canopy
assembly
SP4E end feed
suspension
bracket
SP4P point
suspension
bracket
Max 4 ft interval
MOUNTING THE TRACK
NOTE: The track should be securely mounted at the maximum intervals of the 4ft, and must be
mounted in accordance with all applicable codes and standards.
Ceiling mounting options Instructions for each option:
A. Using the factory provided mounting holes, use appropriate screw or
toggle bolt for securing the track to the ceiling.
B. Mark the location of the centerline of the track on the ceiling. Using an
appropriate screw or toggle bolt, secure SKB mounting clips at the
correct position on ceiling. Loosen the set screw on the side of the clips
and insert the track, tightening the set screws while holding the track
position.
C. Use the SKBT 12 for securing the track to T-bar ceiling grids. Snap the
clips onto the grid in the correct locations, then insert the track,
tightening the set screws while holding the track in the position.
D. Use the SKBX 12 for T-bar grid recessed into the ceiling tile. Follow the
same procedure as C above.
SPXX Stem
and canopy
assembly
SKB 12
SKBT 12
SKBX 12
Electrical feed through pendant feed stem, Catalog numbers SP XX.
1. Secure mounting bracket to outlet box using hardware provided.
2. Thread one nut on upper end of feed stem. Pass required supply
wires and ground wire (by others) through second nut and through
feed stem. Attach upper threaded portion of stem to mounting
bracket and secure second nut tightly.
3. Loosen lock screw and slide canopy up stem, taking care not to
scratch the surface finish. Tighten canopy once in position.
4. Remove plastic cover from SP 4E mounting bracket. Using a sharp
knife, cut out the top protrusion to allow the feed stem to pass
through cover. Slide cover up stem while completing remaining
connections.
5. Pass supply and ground wires through metal bushing of SP 4E
mounting bracket. Thread bracket onto stem and tighten.
6. Cut out knock-out on back side of live end feed connector using a
sharp knife. Pass wires from the mounting bracket through the
knock-out and attach live end to track.
7. Secure mounting bracket to back of track, fastening the set screws.
8. Attach supply leads and ground wire to proper screw terminals in
the live end and replace the cover.
9. Slide mounting bracket cover down the stem and over the
mounting bracket.
Track support using pendant stem, Catalog numbers SP XX.
1. Secure mounting bracket to outlet box using hardware provided or
other appropriate fasteners.
2. Thread one nut on upper end of feed stem. Attach upper threaded
portion of stem to mounting bracket and secure second nut tightly.
3. Loosen lock screw and slide canopy up stem, taking care not to
scratch the surface finish. Tighten canopy once in position.
4. Remove plastic cover from SP 4P mounting bracket. Using a sharp
knife, cut out the top protrusion to allow the feed stem to pass
through cover. Slide cover up stem while completing remaining
connections.
5. Thread SP4P metal bracket onto stem and tighten.
6. Secure mounting bracket to back of track, fastening the set screws.
7. Slide mounting bracket cover down the stem and over the
mounting bracket.
(XX = Stem length in inches )
Live end feed