Altman Lighting Track Lighting: GLOBALtrac tec 2-circuit / 2-neutral track system User Manual

Page 5

FEEDING TRACK AT A CORNER CONNECTOR

INSTALLING CONNECTORS

Select the correct connector to fit the end of the track.

Align the guide lug of the connector with the groove on the

track.

Insert the connector into the end of the track, ensuring that

the guide lug enters the groove in the base of the track.

If the connection is too tight, loosen the lock screw until the

connector slides in.

Once the connector is correctly inserted, tighten the lock

screw.

GLOBAL tek track can be fed at the following corners and track intercept connectors

When feeding at one of the above connectors, follow the feeding instructions as shown

under ‘INSTALLATION OF GLOBAL TEK TRACK TO AN OUTLET BOX’.
NOTE: The track is polarized, so connectors can only be installed in the track in one

direction. I, L, T, X-connectors are pre-wired, and should not be re-configured in the

field. When requiring a turn in a different direction, or if an opposite T-connector is

required,remove the cover and turn the connector as shown above.

Bent TEK 34

L-connector

TEK 39 T-connector

TEK 40 T-connector

34 L-connector

Bent TEK 39 T-connector

NOTE: Dark line

directs polarity

ridge on track.

TEK 38 X-connector

TEK

Bent TEK 40

T-connector

TEK 14 Middle feed

TEK 21 Straight connector