Allen&Heath GR05 - Manual (Page 3)

GR05 User Guide 3
Safety Warning !
Do not remove the cover while mains is connected . Mains voltage is dangerous
and can kill. Mains voltage is present within the unit. Do not carry out any work within the unit
while it is powered except for installation calibration. High voltage components are insulated for
safety but should not be touched with power applied. Do not attempt to remove the main circuit
assembly from the chassis. Refer service work to qualified service personnel only.
This equipment must be earthed. To ensure your safety the mains earth is connected to
the chassis through the power lead. Do not remove the mains earth connection.
Important Mains plug wiring instructions.
The console is supplied with a moulded mains plug fitted to the AC mains power lead. Follow the
instructions below if the mains plug has to be replaced. The wires in the mains lead are coloured
in accordance with the following code:
The wire which is coloured Green and Yellow must be connected to the terminal in the plug which
is marked with the letter E or with the Earth symbol. This appliance must be earthed.
The wire which is coloured Blue must be connected to the terminal in the plug which is marked
with the letter N.
The wire which is coloured Brown must be connected to the terminal in the plug which is marked
with the letter L.
Precautions
Mains Voltage
The mains voltage setting is factory wired and is marked
on the rear panel. Check that this matches your local
mains supply. Ensure that the mains lead is fitted with
the correct safety approved mains plug.
Ventilation
The rear panel and top panel may run slightly warm.
This is normal. Do not completely cover the unit. Ensure
that there is adequate air flow around the unit.
Operating Environment
Protect from excessive dirt, dust, heat or cold and
vibration when operating, shipping or storing the unit.
Moisture
Avoid liquid spillage and exposure to rain and moisture.
Should the unit become wet switch off and remove
mains power immediately. Allow the unit to dry out
completely before switching on again.
Cleaning
Avoid the use of chemicals, abrasives and solvents. The
panels are best cleaned with a soft brush and dry lint-
free cloth.
Audio Connections
Do not connect sources of AC or DC power or the output
of power amplifiers directly to the audio input or output
connectors.
WIRE COLOUR TERMINAL
European USA/Canada
L LIVE BROWN BLACK
N NEUTRAL BLUE WHITE
E EARTH GND GREEN & YELLOW GREEN