Allen&Heath GL2200 USER GUIDE - Manual (Page 6)

GL2200 U SER G UIDE 6
C
ONNECTING
P
OWER TO THE CONSOLE
Refer to the SAFETY WARNING on page 4 of this User Guide. Read and understand the warnings
and instructions printed on the rear panel of the console and printed here.
The GL2200 console can be powered from either the internal power supply, from an external
DC supply such as the Allen & Heath RPS11, or both together. The LED indicators on the rear
panel illuminate to indicate which supply is active.
Normally the internal power supply will be used to power the console by the standard 3 pin IEC
mains input connector. A mains cable with moulded mains plug suitable for the local supply is
supplied. Check that the correct mains lead with moulded plug has been supplied with your
console. Ensure that the IEC mains plug is fully inserted into the rear panel socket before
switching on.
P OWER S UPPLY
The internal power supply for the GL2200 is a switch mode supply and will operate from a wide
range of mains input voltages. It produces the DC voltages required by the console. Before
switching on your console, check that the ac mains fuse is of the correct type and rating. This is
clearly marked on the rear panel of the console. Do not replace the fuse with any other type, as
this could become a safety hazard and will void the warranty.
AC~ mains input voltage Fuse value
100 - 230V ±10% T 1A 250V 20mm
DO NOT OB
SEE INSTA
WARNING: TO REDUC
T1A 250V 20mm
WARNING - THIS APPARATUS MUST BE EARTHED.
EXTERNAL SUPPLY INTERNAL SUPPLY
ACTIVE ACTIVE
100 - 240V~
100 - 240V.AC
47-63Hz ~ 60W MAX
SUPPLY VOLTAGE RANGE:
NO USER S
WARNING: DISCONNECT SUPPLY BEFORE CHANGING FUSE.
ATTENTION: COUPER L'ALIMENTATION AVANT DE CHANGER LE FUSIBLE.
CAUTION: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE REPLACE FUSE
ATTENTION: REMPLACER LE FUSIBLE AVEC UN DES MEMES CARACTERISTIQUES.
WITH SAME TYPE AND RATING.
Ensure adequate ventilation around the console. Do not cover the
console or position it on soft furnishings during operation.
The console must be connected to 0V ground by either the a.c.
mains input cable or by the EXTERNAL DC IN cable.
CAUTION: For continued protection against the risk of fire, replace
fuse only with the correct type and value.
The console power supply unit contains no user serviceable parts.
Do not remove the cover. Refer servicing to qualified service
personnel only.