Anel, Ayout, Pecifications – Allen&Heath GL2200 USER GUIDE User Manual
Page 24: Gl2200, Onnections, Uide
GL2200
U
SER
G
UIDE
24
R
EAR
P
ANEL
L
AYOUT
S
PECIFICATIONS
0 dBu = 0.775 Volts rms 0 dBV = 1 Volt rms
HEADROOM:.............................................................. +21dB
MAX OUTPUT: .............. ……XLR +25dBu 2kohm max load
............................................JACK +21dBu 2kohm max load
METERS: L, R……………….peak reading 12 bar LED
Groups 1-4……….peak reading 4 segment LED
Channels…………peak reading 4 segment LED
PEAK LEDs: .............................Turn on 5dB before clipping
FREQUENCY RESPONSE referred to 1kHz @ +4dBu:
Any input to any output .....................20Hz to 30kHz +0/-1dB
DISTORTION: THD+Noise @ +14dBu 1kHz
Mic in to L-R output, 40dB gain .................................0.010%
Line in to L-R output, 0dB gain ..................................0.008%
CMRR
Mic in, 40dB gain @ 1kHz .......................................... >88dB
CROSSTALK: Referred to driven channel @ 1kHz
Adjacent channel ……………………………………... < -90dB
Channel fader off.......................................................< -90dB
Channel mute on .......................................................< -90dB
Channel Pan pot isolation .........................................< -80dB
NOISE: Measured rms, 22kHz bandwidth
Mic input EIN (150 ohm source)..............................< -128dB
Line preamp, 0dB gain ............................................< -83dBu
L-R output residual noise .....................< -92dBu (96dB S/N)
L-R faders ‘0’, nothing routed ...............< -88dBu (92dB S/N)
L-R mix noise (16 channels routed) .....< -83dBu (87dB S/N)
Group, faders ‘0’, nothing routed..........< -91dBu (95dB S/N)
Group mix noise (16 channels routed).< -83dBu (87dB S/N)
POWER SUPPLY: ....................100 to 240V AC @ 47/63Hz
....................................Internal, autosensing AC mains input
Power consumption:............................................... 60W max
Mains Fuse rating 100-240VAC: ............... T1A 250V 20mm
C
ONNECTIONS
INPUTS:
Mic in.............................. XLR......................... pin 2 hot, 3 cold, balanced .................... >2k Ohm ..........variable -60 to -20dBu
Line in ............................ XLR......................... pin 2 hot, 3 cold, balanced .................... >10k Ohm ........variable -30 to +10dBu
or TRS jack ................. tip hot, ring cold, balanced .................... >10k Ohm ........variable -30 to +10dBu
Stereo Ch Line in ........... TRS jack ................. tip hot, unbalanced ................................ >8k Ohm .........-20dBu min
Stereo Return ................ TRS jack ................. tip hot, unbalanced ................................ >6k Ohm ..........-10dBV min
2-Track Return ............... RCA PHONO .......... unbalanced ............................................ >10k Ohm ........-10dBV min
Insert Return .................. TRS jack ................. tip send, ring return, unbalanced........... >6k Ohm ..........0dBu (chan), -2dBu (out)
OUTPUTS:
L-R, Group out ............... XLR......................... pin 2 hot, 3 cold, balanced .................... <75 Ohm..........+4dBu, +27dBu max
Direct out ....................... TRS jack ................. tip hot, impedance balanced ................. <75 Ohm..........0dBu
2-Track sends ................ RCA PHONO .......... unbalanced ............................................ <75 Ohm..........variable +21dBu max
Aux out.......................... TRS jack ................. tip hot, impedance balanced ................. <75 Ohm..........variable +21dBu max
Mono out ........................ XLR......................... pin 2 hot, 3 cold, balanced .................... <75 Ohm..........+4dBu, +27dBu max
Insert send ..................... TRS jack ................. tip send, ring return, unbalanced........... <75 Ohm..........0dBu (chan), -2dBu (out)
Monitor out ..................... TRS jack ................. tip left, ring right, unbalanced ................ <75 Ohm..........variable +21dBu max
Phones out..................... TRS jack ................. tip left, ring right ..................................... for stereo headphones 30 to 600 Ohms
REVERSE
GRP/AUX
5
AUX
R
6
OUT
M
OUT
SEND
L
OUT
4
OUT
2
OUT
1
3
OUT
OUT
L
MONITOR
AUX
6
R
INSERT
RING R
TIP L
1
2
AUX
AUX
4
AUX
3
AUX
AUX
5
INSERT
INSERT
INSERT
INSERT
INSERT
GRP
19
RETURN
2-TRACK
RETURN
R
20
STEREO
RETURN
STEREO
R
L/MONO
18
L/MONO
17
DO NOT OBSTRUCT VENTILATION OPENINGS
AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR.
SEE INSTALLATION INSTRUCTIONS BEFORE CONNECTING TO THE SUPPLY
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE
T1A 250V 20mm
WARNING - THIS APPARATUS MUST BE EARTHED.
EXTERNAL SUPPLY
INTERNAL SUPPLY
ACTIVE
ACTIVE
100 - 240V~
100 - 240V.AC
47-63Hz ~ 60W MAX
SUPPLY VOLTAGE RANGE:
NO USER SERVICEABLE PARTS INSIDE
WARNING: DISCONNECT SUPPLY BEFORE CHANGING FUSE.
ATTENTION: COUPER L'ALIMENTATION AVANT DE CHANGER LE FUSIBLE.
CAUTION: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE REPLACE FUSE
ATTENTION: REMPLACER LE FUSIBLE AVEC UN DES MEMES CARACTERISTIQUES.
WITH SAME TYPE AND RATING.
TALKBACK
SYS-LINK
OUT
DIRECT
10
OUT
DIRECT
DIRECT
9
OUT
8
OUT
DIRECT
DIRECT
7
OUT
6
OUT
CAUTION
DIRECT
DIRECT
5
OUT
4
OUT
DIRECT
DIRECT
3
OUT
2
OUT
DIRECT
1
OUT
INSERT
INSERT
INSERT
INSERT
INSERT
SYS-LINK
14
16
12
MIC
R
IN
11
MIC
R
MIC/LINE
STEREO
IN
IN
15
L/MONO
STEREO
IN
LINE
IN
13
L/MONO
10
IN
IN
MIC/LINE
MIC/LINE
IN
IN
MIC/LINE
MIC/LINE
LINE
IN
LINE
IN
9
8
LINE
IN
LINE
IN
7
6
INSERT
INSERT
INSERT
INSERT
INSERT
IN
IN
MIC/LINE
MIC/LINE
IN
IN
MIC/LINE
MIC/LINE
LINE
IN
LINE
IN
5
4
LINE
IN
LINE
IN
3
2
IN
MIC/LINE
LINE
IN
1