AirLive WMM-3000R - Manual (Page 92)

AirLive WMM-3000R User ’s Manual 89
3.How to reset to factory default?
A: There are 2 methods to reset to default.
1. Restore with RESET button
First, turn off the router and press the RESET button in. And then, power on the router and push the
RESET button down until the M1 and or M2 LED (or Status LED) start flashing, then remove the finger.
If LED flashes about 8 times, the RESTORE process is completed. However, if LED flashes 2 times,
repeat.
2. Restore directly when the router power on
First, push the RESET button about 5 seconds (Status will start flashing about 5 times), remove the
finger. The RESTORE process is completed.
4.How to do recovery mode when the router is abnormal ?
A: Allocate a Static IP Address on your computer as below:
Step1:First, press the reset button and power on the router until Status blinks very ffast.
Step2:Find the Inter Protocol(TCP/IP) Properties from My Network Places and check Properties
of Local Area Network Connection. And click the “General” icon and assign one IP address
which can be from 192.168.1.1 to 192.168.1.253. Here we use the 192.168.1.88 as
the IP address. The Subnet mask must be 255.255.255.0, and the Default gateway must
be 192.168.1.254. Then click “OK” button to complete TCP/IP setup.
Step2: Open the command mode and input “cmd” then check if the router replies to ping
192.168.1.254