Wireless broadband router configuration, Login to the wireless broadband router through lan, Ireless – AirLive WL-1500R User Manual
Page 16: Roadband, Outer, Onfiguration
Wireless Broadband Router Configuration
First make sure that the network connections are functioning normally.
This Wireless Broadband Router can be configured using Internet Explorer 5.0 or newer web browser versions.
Login to the Wireless Broadband Router through WLAN
Before configuring the Wireless Broadband Router through WLAN, make sure that the SSID, Channel and the WEP is set
properly.
The default setting of the Wireless Broadband Router that you will use:
SSID:
airlive
Channel:
6
Security:
disable
IP Address:
192.168.1.254
Login to the Wireless Broadband Router through LAN
Before you configure this device, note that when the Wireless Broadband Router is configured through an Ethernet
connection, make sure the host PC must be set on the
IP sub-network that can be accessed by the xDSL/Cable modem.
For example, when the default network address of the xDSL/Cable modem Ethernet interface is 192.168.1.x, then the
host PC should be set at 192.168.1.xxx (where xxx is a number between 2 and 254), and the default subnet mask is
255.255.255.0.
Using the Web Browser
Open Internet Explorer 5.0 or above Internet browser.
(the factory-default IP address setting) to the URL web address location.
Figure 9. Web address
When the following dialog box appears, enter the user name and password to login to the main configuration window, the
default username and password is “airlive”.
Figure 10. Login
Note: If needed to set a password, then refer to the
System – Password Setting.
After entering the password, the main page comes up, the screen will display the device information.
AirLive WL-1500R User’s Manual
13