AirLive HP-3000E - Manual (Page 9)

AirLive HP-3000E User’s Manual
6
Chapter II : Setup
Configuration requires the use of a Windows PC. Once configured, any device may be connected to
the 200Mbps Powerline Ethernet Adapter's Ethernet port. To perform configuration, follow this
procedure.
1. Connect a standard LAN cable from the 200Mbps Powerline Ethernet Adapter's Ethernet
port to your PC.
2. Plug the 200Mbps Powerline Ethernet Adapter into a normal AC power point.
3. Wait a few seconds for startup to be completed, and then check the LEDs

The Power LED should be ON.

The PLC Link LED will be ON if other Powerline devices are detected, otherwise it will
be OFF.

The Ethernet LED should be ON.
4. Insert the supplied CD-ROM into your Windows PC, and wait for it to start. If it does not start
automatically, locate and run SETUP.EXE.
5. Follow the prompts to install the HP-3000E utility.
6. Microsoft .NET Framework 1.1 is needed for installing HP-3000E utility. The wizard will
check automatically whether the Microsoft .NET Framework 1.1 was installed on your PC
or not. If not, the wizard will pop up a message box. Click OK to install Microsoft .NET
Framework 1.1 first.