AirLive HP-3000E - Manual (Page 13)

AirLive HP-3000E User’s Manual
10
Chapter III : Security Button
This section describes how to use Security button for configuration in the following situations:

Two unassociated adapters (a,b) are forming a new
network (Network AB).
The procedure is as follows:
1. Press the security button on the adapter (a) for less than 3 seconds.
2. Press the security button on the adapter (b) for less than 3 seconds.
3. The Power LEDs start to flash.
4. After a few seconds, the Power and PLC link LEDs should be on. The configuration is
successful.
Join an unassociated adapter (c) to an existing network (Network AB).
The procedure is as follows:
1. Press the security button on the adapter a (or b) for less than 3 seconds.
2. Press the security button on the adapter (c) for less than 3 seconds.
3. The Power LEDs start to flash.
4. After a few seconds, the Power and PLC link LEDs should be on. The configuration is
successful.