AirLive GW-300NAS - Manual (Page 64)

4. Troubleshooting
AirLive GW-300NAS User’s Manual 60
Note: It is recommended that you use an
Ethernet connection to configure it
4
4. Troubleshooting
This Chapter provides solutions to problems for the installation and operation of the WiFi
Broadband Router. You can refer to the following if you are having problems.
Why can’t I configure the router even the cable is plugged and the LED is lit?
Do a Ping test to make sure that the WiFi
Broadband Router is responding.
Go to Start > Run.
Type cmd.
Press OK.
Type ipconfig to get the IP of default gateway.
Type “ping 192.168.1.254”. Assure that you ping the correct IP Address assigned to the WiFi
Broadband Router. It will show four replies if you ping correctly.
Ensure that your Ethernet Adapter is working, and that all network drivers are installed properly.
Network adapter names will vary depending on your specific adapter. The installation steps
listed below are applicable for all network adapters.