AirLive CU-720PIR - Manual (Page 30)

4. Monitor the Image Section
25 AirLive CU-720PIR User’s Manual
4.2.5 PPPoE
PPPoE: Stands for Point to Point Protocol over Ethernet
A standard builds on Ethernet and Point-to-Point network protocol. It allows your device
with xDSL or cable connects with broadband network directly, then your device can dial up
and get a dynamic IP address. For more PPPoE and Internet configuration, please consult
your dealer or ISP.
The device can directly connect to the xDSL, however, it should be setup on a LAN
environment to program the PPPoE information first, and then connect to the xDSL modem.
Power on again, then the device will dial on to the ISP connect to the WAN through the
xDSL modem.
The procedures are
• Connect to a LAN by DHCP or Fixed IP
• Access the device; enter Setting Î Network Î PPPoE as below
PPPoE:
To enable or disable the PPPoE service here.