ADS-TEC BPC1000 - Manual (Page 17)

Industrial PCs BPC1000
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
17
5.3 24 V DC POWER SUPPLY
The power supply voltage is supplied via a feed-through clamp including screw
connection (figure shows socket in the device).
Technical data of the power adapter
• Power consumption: Max. 60 Watts
• Input voltage: 24V DC
Note:
The typical power consumption of this device is indicated in the "Technical details"
chapter.
5.4 USB CONNECTIONS
The USB interfaces are used for connecting peripherals with USB connection. The interface
complies with the USB 2.0 standard.
PIN NUMBER SIGNAL NAME
1 VDC
2 D -
3 D+
4 GND
Note:
The USB interfaces may be locked using the Lock USB software tool.
You'll find the software and the documentation on the service CD.
5.5 N
ETWORK CONNECTION
(RJ45)
If the drivers required for functioning are installed on the device, the control system may
be integrated in an Ethernet network supporting the 10/100/1000 Mbit standard by using
the Ethernet 10/100BaseT network connector. Specifications of this network topology must
be observed in this case. You can install the drivers required for functioning from the
enclosed service CD, should they not be installed on the device.
PIN NUMBER SIGNAL NAME
1 24V DC
2 PE
3 0 VDC