8 software‐/driver‐installation – ADS-TEC IPC1300 User Manual

Page 21

IPC1300

8 Software‐/Driver‐Installation

The device will be delivered with a pre‐installed Windows operating system on request by the customer. The
drivers required for this are already installed, and the operating system will be enabled by entering the licence
information. Should an initial installation be required, please adhere to the following steps. With a newer
operating system like Windows XP, the network card and graphics card will properly be recognised during initial
installation, so that only the touchscreen driver and the soft keyboard must be installed separately.

Note:

If the hard drive was formatted, the operating system can be reinstalled by using
one of the existing interfaces.

An external keyboard is required for installation.

Installation of the operating system

If the device is not equipped with an integrated drive, installing the operating system can only be carried out by
using the USB interface

Procedure for installation

 The boot drive in the system Bios must be switched to USB in order to boot the

device from the USB interface.

 Restart the device and insert the Windows CD.
 Windows installation and basic data setup
 With devices using a touchscreen, the full functionality range or touchscreen drivers

and the soft keyboard should be installed.

If Windows CE.net or Windows XPe is used, the entire operating system may be completely installed from the
USB stick using the respective image. The required image can be purchased from the ads‐tec company or via the
ASSIX online portal.

Pos: 37 /Datentechnik/Software / Treiber Installation/Touch Screen/Touch Screen Installation für OPC 5112/5212/5315/5515/5317/5319 / CPC5006/OTC5006/ VMT-Serie @ 0\mod_1159175108636_6.doc @ 665 @