beautypg.com

Operation – Echo LS21 Instruction v.3 User Manual

Page 5

background image

Instruction Sheet

5

22. Hook the spring between the lever bottom sheet and

the mount angle. On the quick split kit adjustment

may be necessary in order to achieve idle and full

throttle. Make adjustments at points (a) and (B) to

attain desired RPM settings. Ensure that the screw at

point (B) is not overtightened to the extent that the

cable stop will no longer pivot.

Figure 19. Quick Split

Figure 20. Throttle Down

Figure 21. Installation of new cast wedge bottom plate(B)

OPERATION

QUICk SPLIT

1. Set the point to which the anvil will return by pulling the

ball out and adjusting the slider plate.

2. Move handle to split log.
3. after the log is split, push handle back and release. The

anvil will go back to the set point and then stop. The

engine will automatically throttle down.

THROTTLE DOWN

1. Move handle to split log.
2. after the log is split, push handle back and release. The

anvil will go back to its original location and then stop.

The engine will automatically throttle down.

A

B

23. Remove the existing bottom wedge plate (a) as

shown in Figure 21, by removing the 1/2 nuts and

washers from the three 1/2 x 1-3/4" bolts securing it

to the wedge.

24. Install the new bottom wedge plate (B) that is supplied

in the Quick Split kit by reinstalling the bolts and

hardware, removed in step 23, and tighten securely.

This manual is related to the following products: