Echo LS21 Instruction v.3 User Manual
Page 3
Instruction Sheet
3
Figure 11. Reinstall lever knob
Figures 12 & 12a. Connecting slide angle and new handle
Figure 13. Throttle cable installed in cable clamp
Figure 14. "Z" end of cable inserted in throttle arm
11. Pivot the end of the newly installed slide angle up and
align it with the end of the new handle. attach them
using 5/16 x 1" hex head bolt, two washers and one
nylock nut. Tighten nut and bolt to the point that it still
allows proper operation of handle and slide angle.
12. at this point, verify that all parts of the assembly
are lined up and operating properly, and completely
tighten the 3/8 x 3/4" self-tapping hex bolts installed
in Step 1.
13. Remove the top of the air cleaner assembly to allow
better access for attaching the throttle cable end.
CABLE CLAMP
14. Loosen the cable clamp located next to the throttle
control lever. Place the end of the throttle control cable
through the cable clamp.
15. Make sure several millimeters of cable insulation
are showing and tighten screw until snug. do not
completely tighten.
16. Insert the "Z" end of the throttle cable into the small
diameter hole on the throttle lever as shown in Figure
13.
Steps 13 through 22 are not applicable to
Log Splitter models LS21 and LS21E.
NOTE