Echo LS21 Instruction v.3 - Manual

Instructions
PN 36323-00
Rev. 010112
SUBJECT: QUICK SPLIT (PN
75896-00) aNd THROTTLE dOWN
(PN 75899-00) KITS
FITS MODELS: aLL LOG
SPLITTERS*
Before inspecting or servicing any part of this machine,
shut off power source, remove key, disconnect the
battery cables and make sure all moving parts have
come to a complete stop.
WARNING
1. Install the channel and angle mount assembly on the
right side of the log splitter in the channel with two
3/8 x 3/4" self-tapping hex bolts. IMPORTaNT: If your
log splitter does not have the hex bolt holes already
pre-drilled, see appendix 1 on page 8 for drilling
instructions.
2. do not completely tighten bolts at this point. allow
enough movement to assist in completion of
assembly
3. Pull knob on angle mount assembly out to install slider
plate into channel mount as shown in Figures 3 and
4.
INSTALLATION
NOTE
If the throttle down kit is installed on model LS21160,
you will first need to install a new Control assembly.
Contact your local Honda dealer to order part #
16500-ZL8-800.
Figure 1. Channel and angle mount assembly
Figure 2. Channel and angle mount assembly
Figure 3. Pull knob out to install slider plate
Figure 4. Slider plate installed
NOTE
Throttle down Kit #75899-00 is not designed for use
on LS21 and LS21E Log Splitter models