beautypg.com

Echo LS21 Instruction v.3 User Manual

Page 2

background image

Instruction Sheet

2

6. Install spring on angle assembly. See Figure 7.

7. Remove the existing valve handle by removing the

two pins and cottter pins that attach it to the hydraulic

valve.

8. Replace it with the new handle from the kit and reinstall

original pins and cotter pins to secure.

9. Remove knob from angle mount to allow the installation

of the slide angle.

10. Reinstall lever knob once slide angle is properly

installed.

5. Put a 1/4 x 3/4" hex bolt and nylock nut through the

hole on the end of the slider plate as shown in Figure

6.

Figure 6. Slider plate bolt location

Figure 7. Properly installed spring

Figure 8. Pins to be removed on existing handle

Figure 9. Pins to be installed on new handle

Figure 10. Install slide angle with knob removed

SLIDE ANGLE

4. Continue to hold knob out and push the slider plate

through the channel and angle mount assembly,

Figure 5. Push slider plate through channel mount

This manual is related to the following products: