beautypg.com

Echo LS21 Instruction v.3 User Manual

Page 4

background image

Instruction Sheet

4

20. Remove the wire stop from the throttle cable by

loosening the bolt.

21. attach the cable stop with a screw supplied with the

throttle cable, a #8 washer, and a 3/16" screw to the

lever bottom sheet. Tighten with an allen head wrench

(the lever bottom must be in the vertical position).

17. Loosen the friction nut (Figure 15) on the throttle lever

so the throttle lever moves freely and with very little

resistance. Failure to do this operation will not allow

the throttle cable to move the throttle lever properly or

with the full range of motion.

18. Make sure the throttle is in idle position.

19. Route the throttle cable through the 9/16 coated clamp

and install clamp on the lower right portion of the frame

using 1/4 x 3/4" bolt, washer and nut.

Figure 15. Throttle arm friction nut

Figure 16. Coated clamp for routing of throttle cable

Figure 17. Coated clamp for routing of throttle cable

Figure 18. Cable stop mounting location and position

This manual is related to the following products: