Echo DL10570 Owners Manual v.2 - Manual (Page 13)

Debris Loader Owner’s Manual 9
ASSEMBLY
2.7 ATTACH FLEX HOSE
(MODEL DL12725)
The discharge support must be in place when the debris
loader is towed.
1. Connect the top end of the discharge support to the
clevis at the end of the discharge tube. Use a 5/16" x
2" bolt, two washers and one nylock nut.
2. Connect the other end of the discharge support to the
trailer frame clevis located between the engine and
battery. Use a 5/16" x 2" bolt, two washers and one
nylock nut.
1. Slide the flex hose and clamp ring over the end of the
discharge tube.
2. Evenly tighten the four 3/8" bolts in the ring clamp to
fasten the hose to the discharge tube.
2.5 CONNECT THE BATTERY
(12" MODELS)
You will need to purchase a battery. Choose a battery
that meets or exceeds the engine manufacturer’s
specifications. Consult your engine owner’s manual or
authorized dealer for specification details.
To install the battery:
1. Open the battery box and insert battery into the battery
box.
2. Attach the positive (red) battery cable from the engine
to the positive (+) battery terminal.
3. Attach the negative (black) battery cable from the
engine to the negative (-) battery terminal.
Secure the cover on the battery box with the strap.
2.6 FILL THE TANK
Use only those types of fuels that are recommended in
your engine owner’s manual.
To add fuel:
1. Stop engine, wait for all parts to stop moving and
disconnect spark plug wire. Remove key from key
switch. Allow the engine and muffler to cool for at least
three minutes.
2. Clean area around fuel fill cap and remove cap.
3. Using a clean funnel, fill fuel tank to 1/2” below bottom
of filler neck to provide space for any fuel expansion.
Install fuel fill cap securely and wipe up any spilled
gasoline.
WARNING
Gasoline and diesel fuels are highly
flammable and their vapors are explosive.
To prevent personal injury or property
damage:
Store fuel only in approved containers, in
well ventilated, unoccupied buildings, away
from sparks or flames. A container with a capacity of 2
gallons or less with a pouring spout is recommended.
Do not fill the fuel tank while the engine is hot or
running, since spilled fuel could ignite if it comes in
contact with hot parts or sparks from ignition. Do not
start the engine near spilled fuel. Never use fuel as a
cleaning agent. DO NOT MIX OIL WITH FUEL.
DISCHARGE
SUPPORT
FLEX HOSE
2.8 ATTACH DISCHARGE SUPPORT
WHEN PREPARING TO TRANSPORT
(MODEL DL12725)