4 attach blower discharge – Echo DL10570 Owners Manual v.2 User Manual
Page 12

Debris Loader Owner’s Manual
8
ASSEMBLY
2.4 ATTACH BLOWER DISCHARGE
1. Slide the blower tube discharge clamp
underneath the mounting flange on the
debris loader frame.
2. Install the second half of the shim, spacer
and clamp (included in owner's kit) to the
tube and flange with 3/8" x 1-1/4" bolts
and nylock nuts.
3. Rotate the tube 360 degrees to make sure
it is mounted correctly. Lock it in place with
the lock lever.
BOLT
3/8” x 1-1/4”
NUT
3/8” NYLOCK
CLAMP
DISCHARGE
SPACER
SHIM
TUBE
DISCHARGE
BLOWER
MODELS DL12670 AND DL12725
MODELS DL10570 AND DL8390
LOWER
DISCHARGE
CLAMP
SPACERS
LOWER
DISCHARGE
CLAMP
UPPER
DISCHARGE
CLAMP
KNOB
3/8 X 2-3/4”
CARRIAGE
BOLT
3/8” NYLOCK
NUT
1. Slide the upper discharge clamp down the
discharge tube to the bottom flange.
2. Place the two spacers on the mounting
flange of the debris loader frame.
3. Holding the discharge tube in place on
the mounting flange, position the lower
discharge clamps under the flange.
4. Thread the four (4) 2-3/4" carriage bolts
through the lower and upper discharge
clamps and spacers and secure with the
four (4) knobs and 3/8" nylock nuts.
5. To direct the discharge tube, loosen all
four knobs, reposition, and then retighten
the knobs.