Echo 71825 - Manual (Page 9)

7
Engine Operation:
Starting
CAUTION: Move machine to a clear, level area outdoors before starting.
Do not operate machine on a paved, concrete, or gravel surface. Do not
operate in the vicinity of bystanders. Make sure cutting chamber is empty
before starting.
1. Before starting, fill engine with oil to the correct level. See engine manual
for operation and maintenance instructions.
Note: Some oil usage is normal. Check level with each use.
WARNING: Handle fuel (gasoline) with care. It is highly flammable. Always
use an approved container and fill tank outdoors. Never add fuel to a
running or hot engine.
2. Before starting, fill fuel tank with fresh, clean unleaded regular gasoline.
DO NOT MIX OIL WITH GASOLINE.
3. Place the throttle control midway between slow and fast positions. Place
the choke control to the ON position.
CAUTION: See operation/start-up decal by foot clutch pedal on machine
before starting.
4. Depress foot clutch pedal down, this will disengage drive belts and enable
engine to start.
5. Activate the starter switch. Release the switch as soon as the engine
starts. Do not crank over for more than 10 seconds.
6. Move choke lever to RUN position. After a short shut down, full choke
may not be necessary. If engine fails to start, move lever to RUN or partial
choke.
7. Once engine is running and no choke is needed, slowly let foot clutch
pedal up. This will engage drive belt and the rotor will turn.
8. If engine kills when engaging foot clutch pedal, either use more choke or
increase engine RPM.
9. When clutch is engaged, the foot pedal may vibrate or shake until the
engine and rotor have increased to full running RPM.
10. The chipper frame assembly can turn 360 degrees clockwise or
counterclockwise. Press down on the foot pedal located underneath the
frame near the tow hitch and the frame will pivot on the trailer to your
desired location. Let up on the foot pedal and the frame will lock into
place for use. The discharge tube can also turn 360 degrees to your
desired location.
WARNING: Return table to towing position and lock in place before moving
machine. Do not move chipper while machine is running.
Note: When restarting a warm engine after a short shut down, it may not be
necessary to use full choke. If the engine fails to start, move lever to run or
partial choke.
CAUTION: Obtain and wear safety glasses at all times when operating the
machine. Do not wear loose fitting clothing. The operator should always
wear heavy boots, gloves, pants, and shirt. Use common sense and
practice safety to protect yourself from branches, sharp objects, and other
harmful objects.
WARNING: Do not leave machine unattended or inspect or service unless
the engine is stopped and the spark plug wire is removed from the spark
plug.