Controls cont, Figure 4 – Echo 71825 User Manual
Page 8
6
Controls Cont.
See Figure 4
5.
Engine Fuel Tank: Use unleaded fuel—do not mix with oil.
6.
Trailer Hitch: Always use 2 inch ball and safety chains.
7.
Jack Stand: Always have in UP position and clear from ground when
moving. When is use, place in DOWN position on a level surface.
8.
Engine Drive Belts and Shield: Never remove shields when in use.
9.
Chipper Chute: Feed materials to be chipped through the chute.
10. Engine Controls
11. Rotor Access Cover: Used to remove chipper blades.
12. Engine Battery (not included)
13. Rotor Shaft End Cover: Covers rotor shaft and bearing. Has lock
assembly to lock in place while moving.
14. Clutch Foot Pedal: Used to engage rotor assembly drive belt.
15. Adjustable Chipping Anvil
16. Foot Pedal: Used to pivot machine 360 degrees.
CAUTION: The chipper rotor may continue to rotate even with the engine
stopped. Do not attempt any repair or adjustments until the entire
machine has come to a complete stop and spark plug wire is removed.
Never operate this machine without all safety shields in place.
14
5
Figure 4
9
8
11
13
15
12
6
7
16
10