Echo 74624 Owners Manual v.1 - Manual (Page 22)

Page 16 6” Chipper Operator’s Manual
Section
5 Service & Maintenance
To prevent personal injury or property damage: Shut
off engine, disconnect spark plug wire and make sure
that all moving parts have come to a complete stop
before, servicing, adjusting or repairing.
WARNING
5.1 MAINTENANCE SCHEDULE
The following items listed in the service and maintenance
schedule are to be checked and if necessary, corrective
action should be taken. This schedule is designed for units
operating under normal conditions. If the unit is operating in
adverse or severe usage conditions it may be necessary for
the items to be checked and serviced more frequently.
See engine owners manual for further maintenance and
troubleshooting information.
COMPONENT
MAINTENANCE
REQUIRED
Refer to Engine
Operator manual
EVERY 8
HOURS
EVERY
25
HOURS
EVERY
50
HOURS
EVERY
200
HOURS
EVERY
YEAR
AIR CLEANER CHECK AND CLEAN (1)
•
AIR INTAKE CLEAN (1)
•
ENGINE OIL CHANGE (1)
•
FUEL FILTER REPLACE
•
SPARK PLUG
CHECK CONDITION AND
GAP
•
ENGINE OIL CHECK
•
FUEL TANK FILL
•
CHIPPER ANVIL
CHECK 1/16" TO 1/8"
CLEARANCE AND RE-
TORQUE TO 75 FT. LBS. (2) •
CHIPPER BLADES
CHECK SHARPNESS AND
RETORQUE TO 75 FT. LBS.
(2) •
ALL INTERNAL AND
EXTERNAL NUTS AND
BOLTS
RE-TORQUE PER
ASSEMBLY TORQUE CHART
•
BELT CONDITION CHECK
•
BELT TENSION CHECK
•
GREASE ZERKS LUBE
•
ENTIRE MACHINE CLEAN
•
HYD. OIL FILTER REPLACE
•
WHEEL BEARINGS CHECK AND REPACK
•
FREQUENCY
SERVICE AND MAINTENANCE SCHEDULE
(1) PERFORM MORE FREQUENTLY UNDER EXTREMELY DUSTY CONDITIONS.
As the Chipper Limited Warranty states, failure by the Owner to perform normal maintenance will void the machine's
warranty. The aggressive, high-speed nature of chipping REQUIRES THE OWNER TO PERFORM THE ABOVE LISTED
NORMAL MAINTENANCE. Special consideration to maintain and re-torque the CHIPPER ANVIL, CHIPPER BLADES, AND ALL
INTERNAL AND EXTERNAL NUTS AND BOLTS is the sole responsibility of the Owner. Failure by the Owner to do so shall be
cause for Crary BearCat to deny warranty.
(2) PERFORM MORE FREQUENTLY WHEN CHIPPING DRY OR DIRTY WOOD.