Echo 74624 Owners Manual v.1 - Manual (Page 21)

Page 15 6” Chipper Pro Operator’s Manual
4.6 DIRECTING CHIP-
PER CHUTE 4.7 FEED ROLLER
BOTTLE JACK
Operation
1. Move throttle to slowest position.
2. Move chipper engagement to the
engine start position.
3. Let machine idle for a few seconds.
4. Turn key to off position.
5. Allow machine to come to a com-
plete stop.
Allow the machine to come to
complete stop before inspection
or servicing.
WARNING
4.8 STOPPING IN-
STRUCTIONS
Fig. #18, Directing the chute
Fig. #19, Bottle jack
The chipper chute can be locked in 53
different positions using the chute rotor.
The discharge cap can be directed to
adjust how high and how far the chipped
material is blown.
To adjust the chute rotor lift up the rotor
lock. Turn the chute rotor until the
chute faces the desired position. Let
go of the rotor lock and fine tune the
position of the rotor until the lock snaps
in place.
The discharge cap is adjusted by
turning the discharge crank cap either
clockwise or counterclockwise. Turning
the handle clockwise will raise the
position of the discharge cap. Turning
the handle counterclockwise will lower
the position of the discharge cap.
The feed roller bottle jack is used to
raise the feed roller if chipping material
becomes wedged in the feed roller. The
jack will raise the feed roller and remove
the tension on the chipped material.
Turning the check valve clockwise will
engage the pump of the jack. Once the
jack is engaged pumping the handle
will raise the jack. Turning the check
valve counterclockwise will disengage
the pump and lower the jack.