Echo 74624 Owners Manual v.1 - Manual (Page 14)

Page 8 6” Chipper Operator’s Manual
Assembly
2.9 ATTACHING THE
BATTERY
The chipper is shipped with a battery.
The battery is connected to the battery
cables using the two 1/4” bolts and
nuts found in the parts kit. To connect:
1. Route the battery cables to the
proper battery terminals, hooking
positive to positive, and negative to
negative.
2. Connect cables with 1/4” bolt and
nuts. Tighten nuts to proper torque.
3. Check battery for proper fluid level
and fill if necessary.
4. If necessary, charge battery.
2.8 INSTALLING THE
REAR STABILIZER
The rear stabilizer is installed by sliding
the stabilizer into the corresponding
slot on the rear of the chipper frame.
The stabilizer is secured and adjusted
with the provided snap pin.
Fig. #10, Rear stabilizer