Echo 74624S Owners Manual v.1 - Manual (Page 23)

Page 17 6” Chipper Pro Operator’s Manual
Operation
4.9 SAFETY BAR OPERATION
4.9.1 Resetting the Chipper
The safety bar located around the chute area will stop the
chipper when pushed in. The reset button for this bar sits on
top of the chipper chute. To reset the safety bar, push the
reset button and the machine will start up again. If false trips
occur from a limb, the reset button can be held in to override
the system. Upon start up, safety bar light will be on and will
require the reset button to be pushed in before the feed roller
will operate. When the safety bar has been activated, a red
light will be on signaling that the operator reset button will
need to be pushed before feed roller will function.
4.9.2 Locking in Travel Position
The safety bar will lock into travel position. Place the exten-
sion tray in an upright position. Pushing the safety bar down
will lock the safety bar (see Figure # 23). To unlock, lower
the extension tray and push in on the safety bar. This will
release the flange and allow the safety bar to move freely.
Figure # 23 Flange lock
Figure # 22 Safety Bar, Reset Button