Echo 74624S Owners Manual v.1 - Manual (Page 15)

Page 9 6” Chipper Pro Operator’s Manual
Assembly
2.8 INSTALLING THE REAR STABI-
LIZER
Install the rear stabilizer by sliding the stabilizer into the
corresponding slot on the rear of the chipper frame. Secure
and adjust the stabilizer with the provided snap pin.
Fig. #11 Rear stabilizer
2.9 ATTACHING THE BATTERY
A battery ships with the chipper. Connect the battery cables
to the battery using the two 1/4” bolts and nuts found in the
parts kit. To connect:
1. Route the battery cables to the proper battery terminals,
hooking positive to positive, and negative to negative.
2. Connect cables with 1/4” bolt and nuts. Tighten nuts to
proper torque.
3. Check battery for proper fluid level and fill if necessary.
4. If necessary, charge battery.
2.7 ATTACHING THE HITCH
1. Attach the channel spacer over the square tube.
2. Attach the ball coupler over the channel spacer to the
hitch weldment using the provided 1/2” x 4” bolts and 1/2”
washers and 1/2” nuts. Tighten to proper torque.
3. Slide the hitch weldment into the hole in the frame, back
to the 1/2” mounting holes.
4. Connect the hitch weldment to the frame using the two 1/
2” x 4-1/2” bolts, 1/2” washers and 1/2” nuts. Tighten to
proper torque.
5. Check the tongue jack and safety chains for correct
installation.
Fig. #10 Trailer hitch