Echo 74624S Owners Manual v.1 - Manual (Page 12)

Page 6 6” Chipper Operator’s Manual
Assembly
2.3 ADDING COOLANT
(DIESEL ONLY)
You may need to add coolant before you start the diesel
engine. While operating, check the fluid to ensure the level
sits between the full and the low marks. Add if necessary.
To fill:
1. Remove the top cover.
2. Add a 50/50 mix of water and antifreeze until it reads
slightly below the full line. (The antifreeze should drain
from the tank into the radiator).
3. Wait 10 minutes and check level again. Refill if neces-
sary.
4. After running the machine, recheck the level of antifreeze,
and fill if necessary.
Fig. #7 Coolant level