Echo 76624 Owners Manual v.1 - Manual (Page 11)

9 6 INCH CHIPPER
ASSEMBLY
2.4 insTall rear sTabilizer
2.5 check baTTerY
the chipper is shipped with a battery. the battery is
connected to the battery cables using the two 1/4” bolts
and nuts found in the parts kit. to connect:
Route the battery cables to the proper battery termi-
nals, making sure the positive is connected to positive,
and negative to negative.
Connect cables with 1/4” bolt and nuts. tighten nuts
to proper torque.
If necessary, charge battery.
1.
2.
3.
the rear stabilizer is installed by sliding the stabilizer into
the trailer support guide on the rear of the chipper frame.
The stabilizer is secured and adjusted with the provided
snap pin.
2.7 fill The Tank
Gasoline is highly flammable and its vapors are explosive.
To prevent personal injury or property damage:
Store gasoline only in approved containers, in well venti-
lated, unoccupied buildings, away from sparks or flames.
a container with a capacity of 2 gallons or less with a
pouring spout is recommended. Do not fill the fuel tank
while the engine is hot or running, since spilled fuel could
ignite if it comes in contact with hot parts or sparks from
ignition. do not start the engine near spilled fuel. Never
use gasoline as a cleaning agent. do Not MIx oIl WIth
GaSolINe.
Warning
gasoline alcohol blends
Gasohol (up to 10% ethyl alcohol, 90% unleaded gasoline
by volume) is approved as a fuel for these engines. other
gasoline/alcohol blends are not approved.
gasoline ether blends
Methyl tertiary butyl ether (Mtbe) and unleaded gasoline
blends (up to a maximum of 15% Mtbe by volume) are
approved as a fuel for these engines. other gasoline/ether
blends are not approved.
diesel fuel
For best results, use only clean, fresh #2 diesel. use an
additive for cold weather to prevent the fuel from turning
into a gel.
To add fuel:
Stop engine and wait for all parts to stop moving.
Remove key from key switch. allow the engine and
muffler to cool for at least three minutes.
Clean area around fuel fill cap and remove cap.
using a clean funnel, fill fuel tank to 1/2-inch below
bottom of filler neck to provide space for any fuel ex-
pansion.
Install fuel fill cap securely and wipe up any spilled
fuel.
1.
2.
3.
4.
5.
Rear stabilizer and snap pin
Connected battery