Echo CH611DH Owners Manual v.6 - Manual (Page 8)

4 6 INCH CHIPPER
SAFETY
1.9 SAFETY DECALS
PN 14942-00
3 PN 12173
7
1 PN 12169
2
PN 12172
CHECK BLADE BOLTS FOR
PROPER TORQUE AFTER EVERY
8 HOURS OF OPERATION.
CHECK BLADES AND ROTATE
OR RESHARPEN DAILY OR AS
REQUIRED TO KEEP BLADES
SHARP. REFER TO OWNERS
MANUAL FOR INSTRUCTIONS. FAILURE TO DO SO MAY
CAUSE POOR PERFORMANCE, DAMAGE OR PERSONAL
INJURY AND WILL VOID THE MACHINE WARRANTY.
PN 12250
6
PN 12174 4
8
9
PN 18983-00
PN 32154-00
FEED ROLLER SUPPORT
MUST BE SECURED IN THE
UP POSITION PRIOR TO SER-
VICING CHIPPER FEED AREA.
THE FEED ROLLER CAN FALL
AND CAUSE SEVERE BODILY
HARM. CONSULT OWNERS MANUAL FOR PROPER METH-
OD OF SECURING FEED ROLLER SUPPORT. LOWER FEED
ROLLER BEFORE OPERATING CHIPPER.
PN 12175 5
See Section 1.10 for decal locations. Familiarize yourself with all of the safety and operating decals on the machine
and the associated hazards. See the engine owner’s manual or contact the engine manufacturer for engine safety
instructions and decals. Make certain that all safety and operational decals on this machine are kept clean and in good
condition. Decals that need replacement must be applied to their original locations.
KEEP HANDS AND FEET OUT OF INLET AND
DISCHARGE OPENINGS WHILE MACHINE IS
OPERATING TO AVOID SERIOUS PERSONAL
INJURY. STOP AND ALLOW MACHINE TO
COME TO A COMPLETE STOP BEFORE
CLEARING OBSTRUCTIONS.
READ AND UNDERSTAND THIS OWNER/
OPERATORS MANUAL. BE COMPLETELY
FAMILIAR WITH THE CONTROLS AND
THE PROPER USE OF THIS EQUIPMENT.
OBTAIN AND WEAR SAFETY GLASSES
AND USE HEARING OPERATING THIS
MACHINE. BEFORE INSPECTING OR
SERVICING ANY PART OF THIS MACHINE,
SHUT OFF POWER SOURCE, REMOVE
THE KEY, DISCONNECT SPARK PLUG
WIRE FROM SPARK PLUG AND MAKE
SURE ALL MOVING PARTS HAVE COME
TO A COMPLETE STOP.
DO NOT OPERATE THIS EQUIPMENT
IN THE VICINITY OF BYSTANDERS.
DO NOT ALLOW CHILDREN TO
OPERATE THIS EQUIPMENT. ALWAYS
STAND CLEAR OF DISCHARGE AREA
WHEN OPERATING THIS MACHINE.
KEEP FACE AND BODY AWAY FROM
DISCHARGE AREAS.
DO NOT OPERATE MACHINE WITHOUT
SHIELDS IN PLACE. FAILURE TO DO SO
MAY CAUSE SERIOUS INJURY OR DEATH.
(LOCATED UNDER THE HOOD ON ENGINE
SHIELD BRACE.)
KEEP HANDS AND FEET OUT
OF INLET AND DISCHARGE
OPENINGS WHILE MACHINE IS
OPERATING TO AVOID SERIOUS
PERSONAL INJURY. STOP AND
ALLOW MACHINE TO COME TO A
COMPLETE STOP BEFORE CLEARING OBSTRUCTIONS.
READ AND UNDERSTAND YOU OWNERS MANUAL BEFORE
OPERATING. IF OWNERS MANUAL WAS NOT INCLUDED OR
YOU HAVE ANY QUESTIONS, PLEASE CALL 800.247.7335
OR 701.282.5520 (U.S.A.)
P215/70R15 240 kPa, 35 psi
91 200