Echo CH611DH Owners Manual v.6 - Manual (Page 29)

25 6 INCH CHIPPER
ENGLISH
SERVICE & MAINTENANCE
BEFORE INSPECTING OR SERVICING ANY PART OF THIS MACHINE, SHUT OFF POWER SOURCE,
DISENGAGE THE HYDRAULICS, AND MAKE SURE ALL MOVING PARTS HAVE COME TO A COMPLETE STOP.
WARNING
LOOSEN THESE
TWO BOLTS
HYDRAULIC
DRIVE BELT
IDLER PULLEY
HYDRAULIC
BELT PULLEY
Figure 5.11, Replace hydraulic drive belt as needed
5.12 FILL COOLANT ON DIESEL MACHINE
Figure 5.12, Coolant tank for diesel engine
The diesel engine is tested before shipping. In order to test
the equipment the fluid levels are filled. However, before
starting the machine, and every time the engine is started
thereafter, be sure to check the coolant level. If the level
is low, add fluid.
Refer to the engine owner’s manual for coolant information
and maintenance.
5.13 REPLACING AIR FILTER
Both the diesel and the gas engines used on the 6” chipper
have air filters. Refer to the engine owner's manual
included with your machine for specific instructions on
replacing and cleaning these filters.
5.15 TRAILER SERVICE TIPS
1. Check wheel bolt torque monthly.
2. Check air pressure in tires monthly.
3. Check and repack wheel bearings with grease every
12 months.
4. When towing, always connect the safety chains. Make
sure trailer hitch bolts are tight.
5. Check trailer lights periodically.
5.14 CHANGE OIL
Check the oil level before each use. Change oil as directed
in the engine owner's manual.
Figure 5.13, Air filter location