Echo CH611DH Instruction v.7 - Manual (Page 4)

Instruction Sheet 4
7. pLUG pLUS 1 CONTROLLER INTO MAIN hARNESS
Note that the instructions for this step are different for European and Domestic machines. Choose the section below
that is correct for your machine.
PLUG INTO
PLUS 1
CONTROLLER
PLUG 2-PIN TO
2-PIN ON MAIN
HARNESS
PLUG 4-PIN TO
4-PIN ON MAIN
HARNESS
PLUG 6-PIN TO
6-PIN ON MAIN
HARNESS
TRIANGULAR END
(NOT USED)
CONNECT TO LED
EUROPEAN HARNESS
PLUG INTO
PLUS 1
CONTROLLER
DOMESTIC HARNESS
PLUG 4-PIN TO
4-PIN ON MAIN
HARNESS
PLUG 6-PIN TO
6-PIN ON MAIN
HARNESS
TRIANGULAR END
(NOT USED)
CONNECT TO LED
DOMESTIC (US) MAChINES:
Unplug the main harness from the existing SmartRelay 1.
controller.
Locate the three connectors on the Plus 1 harness.
2.
The connector with the triangular end is NOT USED. 3.
Plug the 6-pin connector into the corresponding 6-pin 4.
connector on the main harness.
Plug the 4-pin connector into the 4-pin connector on
5.
the main harness.
There will be two 2-pin connectors left over on the main
6.
harness. Tape them together and out of the way.
Plug the two black and gray connectors on the other
7.
end of the Plus 1 harness to the corresponding
receptors on the Plus 1 controller.
EUROpEAN MAChINES:
Unplug the main harness from the existing SmartRelay 1.
controller.
Locate the four connectors on the Plus 1 harness.
2.
The connector with the triangular end is NOT USED. 3.
Plug the 6-pin connector into the corresponding 6-pin 4.
connector on the main harness.
Plug the 4-pin connector into the 4-pin connector on
5.
the main harness.
Plug the 2-pin connector into the red/black and light
6.
green 2-pin connector on the main harness.
There will be one 2-pin connector left over on the main
7.
harness. Tape it out of the way.
Plug the two black and gray connectors on the other
8.
end of the Plus 1 harness to the corresponding
receptors on the Plus 1 controller.