Echo CH611DH Instruction v.7 - Manual

Instructions
SUBJECT: PLUS 1 CONTROLLER
INSTALLATION KITS 76170-00 AND
76171-00
FITS MODELS: 6" CHIPPERS
CH6670H (76624), CH611DH
(76628), CH6993H (76635)
Before inspecting or servicing any part of this machine,
shut off power source, remove key, disconnect the
battery cables and make sure all moving parts have
come to a complete stop.
WARNING
3. DRILL MOUNTING hOLES
To mount the Plus 1 controller on the engine shield brace, drill two holes 11/32" in diameter in the shield brace in the
positions shown below. They should be drilled on the side of the machine closest to the control panel. (Note: in newer
machines these holes have already been drilled.)
5”
4”
These instructions will describe how to install the Plus 1
controller.
PN 75984-00
Rev. 081110
2. REMOVE SNUBBER hARNESS IF ONE WAS pREVIOUSLy INSTALLED
The Plus 1 Controller will not work if a snubber harness
was previously installed on your chipper. To check this,
look at the valve assembly (pictured at right).
If your valve assembly looks like the one pictured, •
a snubber harness was not installed on your machine
and you may procede with Plus 1 installation.
If your valve assembly does not look like the one
•
pictured because a snubber harness was connected
in the places shown by arrows, you must unplug the
connectors, remove the snubber harness, and plug
the connectors back in so that your valve assembly
looks like the one shown here.
1. CONFIRM KILL SWITCh WAS REWIRED ON Ch6670h
Before installing the Plus 1 controller, confirm that the kill switch on the CH6670H has been correctly rewired as described
in Service Bulletin 07-007 (see Distributor/Dealer Tools at http://bearcatproducts.com/).
ENGLIS
h
FRANÇAIS